This product has been phased out. At this time, no support, accessories, or repair are available. If you are looking for an upgrade path, please check out the ALL-100 Family.

No installation program is required. Just unzip F700.ZIP to the same directory as your existing software. If you have adapters with the "ADP-" or "TUP-" prefix download F700ADP.ZIP as well. If you have packs other than PACK-DIP40 also get the appropriate PACK software below. After unzipping execute access.exe to enter the main program. Contact us if you have any difficulties installing the updated software.

Complete update for FLEX-700 + PAC-DIP32/40/48. This update does not include adapter drivers. Access V9.23:

Windows 3.1/95/98 (MS-DOS Mode) F700.ZIP (File 1 of 1) 2,854KB Last Updated: September 9, 2002

Complete update for all Adapters for the FLEX-700:

Windows 3.1/95/98 (MS-DOS Mode) F700ADP.ZIP (File 1 of 1) 4,433KB Last Updated: September 9, 2002

Complete update for the PAC-PLCC44 add-on to the FLEX-700:

Windows 3.1/95/98 (MS-DOS Mode) F700P44.ZIP (File 1 of 1) 971KB Last Updated: September 19, 2000

Complete update for the PAC-PLCC68 add-on to the FLEX-700:

Windows 3.1/95/98 (MS-DOS Mode) F700P68.ZIP (File 1 of 1) 487KB Last Updated: September 19, 2000

Complete update for all of the FLEX-700 PACs other than PAC-PLCC44 and PAC-PLCC68:

Windows 3.1/95/98 (MS-DOS Mode) F700PCK.ZIP (File 1 of 1) 917KB Last Updated: September 19, 2000

FLEX-700 Diagnostics

The latest releases of the FLEX-700 software include diagnostic utilities you can use to test your hardware if you are experiencing difficulties. Every FLEX-700 is now shipped with the POD-DIAG40. This is a small PCB that plugs into the PAC-DIP40 or PAC-DIP48. With the POD-DIAG40 inserted you can execute the file DIAG07.EXE to test your hardware. If you do not have the POD-DIAG40 then you can make one easily. (See Instructions)

There is another file called DIAG07C.EXE. This file can be used to test the FLEX-700 with PAC-DIP40, WITHOUT the diagnostic pod. All adapters and chips need to be removed before use.

There is another file called DIAGXX.EXE. This file can be used to test the FLEX-700B/P base unit by itself. All PACK's need to be removed before using this utility.

PLEASE NOTE: All of these programs can be run with the /D suffix in order to show details. If this option is not selected, the program will stop on the first failure. Also, the diagnostic may fail if communication cannot be established with the programmer. Always first verify that the programmer shows EXIST under Setup -> I/O base address in the main program software.

Windows 3.1/95/98 (MS-DOS Mode) DIAG07.EXE (File 1 of 1) 27KB DIAG07C.EXE (File 1 of 1) 42KB DIAGXX.EXE (File 1 of 1) 49KB Last Updated: January 1, 1998